Simpson SWF12743 - Page 30

30 www.simpson.com.au
6.
7.
Remove the polystyrene base.
8.
Put one of the polystyrene
packaging elements on the floor
behind the appliance. Carefully
put down the appliance with the
rear side on it. Make sure not to
damage the hoses.
Pull up the appliance in vertical
position.
9.
10.
11.
Pull out the plastic spacers.
Remove the power supply cable
and the drain and inlet hoses from
the hose holders (A) on the rear of
the appliance.
Remove the three bolts. Use the
Spanner supplied with the appliance.
A