14
Rotate Selector knob to “Off” position.
Turn off power switch.
1.
To clean the inside and outside of your washing machine you should:
IMPORTANT: Never use solvents, aerosol cleaners, spray pack cleaners, glass
cleaners, metal polishes, caustic materials, scourers or general household cleaners on
or near top panel and lid, control panel or other parts of your washing machine.
Wipe the surface with a mild dishwashing detergent and warm water.1.
Wipe dry with a soft cloth.2.
2.
Switch off the electricity at the power point.
3.
Turn off the water taps.
4.
Leave lid open for a while to allow moisture inside washing machine to evaporate.
5.
Your washing machine will give you long and trouble-free service, if you follow the instructions in this sections.
These instructions show you how to care for your washing machine.
HOW TO CLEAN THE LINT FILTER
Remove the lint filter out from its housing.
1.
Reassemble the filter to the housing.
4.
Open the lint filter.
2.
Clean the filter under the water tap with an old toothbrush.
3.
The dispenser needs to be cleaned regularly, preferably after each wash. Inspect the dispenser after each wash to see if
there is any residue of detergent.
The lint filter needs to be cleaned regulary, preferably after each wash. Inspect the lint filter after each wash to see if there is
any lint collected. To do this proceed as follows:
To do this proceed as follows:
CLEANING THE DISPENSER
Pull the dispenser drawer forward until it stops.
Lift the front of the drawer up and forward to remove it from the runners.
Clean the dispenser drawer with hot water and a brush, eg. an old toothbrush.
Dry the drawer.
Before replacing the dispenser back in its recess, clean the inside of the
drawer with an old toothbrush.
Put the dispenser back into its runners and close the drawer.
Housing Open
Clean
under the
water tap
Filter
To Next Page
Loading...