5
ABOUT YOUR WASHING MACHINE
Out of Balance Interruption
Touchpad Response and Lights
Always press touchpads gently.
NOTE:
The washing machine can stop during the spin stage of a wash because of an out of balance condition. The
display will show “ ” and you will hear a short beep every second.
Out of balance during spin is caused by an uneven distribution of clothes in the wash bowl.
To rectify the out of balance condition, open the lid and redistribute the clothes evenly in the wash bowl. Closing
the lid will start the machine and continue the spin stage of the wash.
If you have frequent out of balance interruptions, it may be due to your washing machine not standing firm and
level on the floor. This can be corrected by adjusting the washing machine legs as described in the Installation
Instructions supplied with your machine.
Watch the lights on the control panel to see the effect pressing a touchpad or turning a program selector knob
has, and listen for “BEEPS”.
When you press a touchpad you will get a short “BEEP” to acknowledge the entry. If the option is not available
at the time, the machine will not allow you to select it. After the machine has started, the entire wash option
touchpad will be disabled and machine will show “ ” on the display with three short beeps to indicate the
touchpad is disabled. The Start/Hold To Pause touchpad is still active but you need to press and hold the
touchpad for minimum 1.2 seconds to pause machine. This is to confirm that you really want to pause the
machine. When in pause mode, all options will be able to be changed again.
This product features the new Ultra Wash System
that uses less amount of water, thus more energy
efficient, during the washing process. It achieves this
with just the right amount of water needed, and by
moving and rolling the laundry for an optimum wash
result.
The water spraying effect helps to dissolve the
detergent faster and it provides an additional gentle
wash action, for a thorough wash.
Wash operation
The low profile agitator & bowl rotates while it is filled with water to partially immerse the clothes.
The low profile agitator then rotates to move the clothes so that the detergent can be dissolved and activated at
the selected water temperature.
Agitation and dilution
After the wash operation is completed, the bowl is filled with more water.
The low profile agitator then moves in an energy efficient mode, generating additional mechanical actions.
All functions of the washing machine will stop when the lid is open, except for pump out before spin.
Ultra Wash System
Your washing machine has selectable “Auto” sensing water level option as well as allowing you to choose a
manual water level if you wish.
We recommend you to use the Auto water level option to ensure there is just the right amount of water for the
wash load in the machine. In other words, it will usually give you the best wash while also being the most
efficient in terms of water usage.
Auto Water Level Feature
water spraying
pump on
drain hose
To Next Page
Loading...