Pole mount
The GS10 attaches to the pole mount adapter with
the supplied 4 mm screws. You can route the cable
through the notch in the module housing and down
the side of the pole, or pass it down through the pole
mount adapter and run the cable inside the pole. The
1” - 14 threads on the pole mount adapter accept a
standard marine antenna mount.
Connecting to SimNet
The GS10 communicates with your navigation system/SimNet net-
work, using NMEA2000 protocols. You can create a NMEA2000 net-
work between the GS10 and a single display unit or SimNet network,
as shown in the following illustrations:
GS10
Display unit
5 m cable SimNet
Tee Joiner
SimNet cable e.g. 2 m (24005837)
12 V
GS10 direct connection to single display unit.
GS10
5 m cable
SimNet
Tee Joiner
(24005860)
GS10 connection to existing SimNet network
SimNet network
A network bus is an installed and operational network cable (back-
bone) running the length of your boat, already connected to a power
supply and properly terminated. Such a bus provides network con-
nection nodes at various locations around your boat. This is similar
3
To Next Page
Loading...