10
CLEANING AND MAINTENANCE
MAINTENANCE
PLEASE REMOVE THE POWER PLUG FROM THE SOCKET BEFORE CLEANING THE UNIT.
COARSE FILTER
The air filters on the side of the unit can be simply removed by pulling the frame sidewards. When cleaning,
use a vacuum cleaner with brush or wash the filters under running, warm water and dry them with a soft
cloth!
Please clean the coarse filters before initial use, and regularly when in use.
ERROR MESSAGES
The mobile air conditioner is equipped with a 3-minute compressor-delay system which means
the compressor needs 3 minutes to start.
This affects the switching on of the unit (POWER) as well as switching over from one function to
the next, e.g. dehumidify to cooling or heating.
ERROR/
PROBLEM
CAUSE REMEDY
Can I switch the
unit on
immediately after
unpacking it?
No.
The unit must be placed upright for at least 24 hours
after every transport. Otherwise the compressor may be
damaged and there is no capacity.
When switching
on the unit I sense
a smell. What
should I do.
Production-related
cause or incorrect
storage of unit at e.g.
dusty areas.
Odour development can arise on first use and after a
longer period of non-use by storing in unsuitable areas
(e.g. dusty areas).
Run the unit for ½ a day. The smell will disappear after a
while. In the case of intensive odour development, air the
room.
Can I operate the
unit WITHOUT the
extract air hose.
No.
To achieve temperature adjustments, surplus heat or
coldness must be discharged.
At which intervals
should the
activated carbon
filter of the unit
be replaced?
To use the purpose of the filter fully, it should be
replaced every 6 months.
How can I
increase the
efficiency of the
unit?
External circumstances exist which may impact the
efficiency of the unit. Room insulation, use of
wall/window adapter, ratio of window space (solar
radiation), operation of electrical units in the room (EDP),
presence of several persons in the room. You can
increase the efficiency of the unit accordingly by
adjusting such circumstances.
Compressor does
not activate
Depending on ambient temperatures and unit type it may
take approx. 10 minutes after starting the compressor
until the cooling/heating capacity is reached.
unit deactivates. On reaching the set required temperature, the unit
switches off automatically.Check manual setting of the
required temperature as well as the TIMER setting.
How is the m² or
m³ data of the
manufacturer
calculated
The m² or m³ data of the manufacturer for the various
units are average values related to a room height of 2.5
metres. It must be considered that such data can be
clearly underscored or exceeded under certain
To Next Page
Loading...
Need help?
General
