Sinclair ASGE-18AI - Page 171

DC INVERTER U-MATCH AIR CONDITION MAINTENANCE
154
mark the position of each
cable correctly.
3. Remove the electric box
sub-assembly
● Use the screwdriver to
remove the screws fixing
the electric box to middle
isolation plate, motor
support and right side plate.
4. Remove the electric box
sub-assembly
● Move the electric box
sub-assembly upward from
the middle isolation plate.
5. Mount a new electric box
sub-assembly
●Assemble the new electric
box sub-assembly to
correct position.
●Use the screwdriver to fix
the electric box
sub-assembly to middle
isolation plate, motor
support and right side plate
according to disassembly
procedures.
6. Connect the power cable
of each component
● Connect the wires of each
component to correct
position according to
disassembly procedures.
For details, please refer to
the wiring diagram.
7. Assemble the electric box
cover
● Assemble the electric box
cover to correct position
and use screwdriver to
tighten the fixing screws.