- 17 -
STEP 3-INSTALLING THE CEILING ASSEMBLY
Make sure that you have properly matched the roof top air conditioner and interior ceiling
assembly.Caution before tightening bolts:
1.The applicable thickness of vehicle roof ranges from 30mm~80mm.
2.
3.When screwing bolts, you can use automatic tool. Do not tighten one bolt completely and then
4.The max torque for tightening ranges from 2.3Nm~2.5Nm.
Before tightening bolts, screw in the four bolts manually and prohibit screwing forcibly.
tighten other bolts, in order to prevent sticking of screw thread.
The following step by step instructions must be performed in the following sequence to ensure proper
installation.
1.
5.
6.
4.
7.
Carefully take the ceiling assembly out of
the carton (The remote control packed with
the ceiling assembly).
Remove the ceiling grille from the ceiling
assembly.
Before installing the outdoor unit of recre-
ational vehicle air conditioner on the
vehicle’s top, preinstall the plate of air vent
and foam (upper) on the chassis of the
outdoor unit with 4pc of screws (25mm long)
(See fig.5-1) .
Then carry the outdoor unit to the vehicle’s
top and align with the openings on the
vehicle’s top. Use 2 sets of mounting plate
assembly and 4 screw bolts to mount the
outdoor unit (See fig. 5).
You must start (thread) themounting bolts
by hand to avoid cross-threading. DO NOT
START THE MOUNTING BOLTS WITH
AN AIR GUN. The mounting bolts should
be tightened, process is completed when
the basepan gasket has been evenly
compressed.
Before installing the air duct assembly of
the indoor unit of recreational vehicle air
conditioner, assemble the foam assembly
according to the thickness of the vehicle’s
top. After simulated installation, use an
appropriate amount of sponge and foam
assembly. Stick the sponge and foam
assembly with double faced adhesive
tape (prepared by user) (See fig.5-2, 5-3).
Install the foam assembly on the air duct
assembly. Use 4 screw bolts to fix the air
duct assembly onto the mounting plate.
After connecting the outdoor unit with
indoor unit, check whether the foam
assembly has come loose (See fig.5).
2.
3.
Thickness of vehicle
roof is from 30mm-80mm
installtion board
Outdoor Unit
Gasket
Gasket
bubble
wind-path
fig 5 4 bolt fig 5-1
4 screw
4 bolt
(Max torque is from
2.3Nm~2.5Nm)
foam(top)
Plate of air vent
To Next Page
Loading...