- 19 -
fig9-1
fig9-2
fig9-3 fig9-4
Insulating sheath
wind-path
fig9-5
fig9-6
front panel
4 shown in the picture, use a piece of thermal insulating jacket to enclose the wiring
terminals and sponge. Then glue the thermal insulating jacket and fasten it with
cable ties.
Note: 1. Cable ties must be attached to the area with both sponge and thermal
insulating jacket; 2. Before installing the front panel of indoor unit, put the thermal
insulating jacket on top of the air duct.
To Next Page
Loading...