· All on-screen instructions MUST be followed. Straying from the
on-screen instructions could cause damage to the machine and the
user.
· Ensure to keep transit hardware in a safe place. These will be
required should the ROTOR HDA require moving.
· During Pad Head removal, always ensure the push cylinder is
cleared before moving away from the carriage. The push cylinder
runs from the carriage arm into The Stinger/Pad Head. If either are
not pulled down far enough during removal, the cylinder will catch
and damage the ROTOR HDA.
· Always ensure the power is OFF before changing heads. Leaving
the power on can cause a hardware crash.
Before you start!
To Next Page
Loading...