Singer 1280 - Page 11

2. Getting Ready to Sew
Choosing and Changing
Accessories
CAUTION: Disconnect the power line plug from the
socket outlet when changing needles, feet, or needle
plates. or when leaving the machine unattended. This
eliminates the possibility of Starting the machine by
accidentally pressing the speed controller.
Changing Presser Feet
a Raise needie to highest position by turning the nang
whee! toward you.
* Raise presser foot.
1. Press toe of presser foot upward as far as it wii co
until li snaps free.
2. Centre the new presser foot under the snank A.
Lower the presser foot lifter so that the shank fis
over the presser foot pin.
3. Press presser foot screw down firmly unti foot
snaps into piace.