Singer 1280 - Straight Stitching; Setting Selectors 0.0.0. Nn

3. Straight Stitching
S000 MAA 100004 Sants ORNL HOLA OAOA NEN IA aeetis WEES JUEGOS ment 00000 diite Abit 0000 AISSO GUND GUA III WINNS OOODE 00000 SHOES TONED 20000 PPOP IOIO
Setting Selectors
Before you move the selectors to set your machine for
straight stiching, turn the hand wheei toward you unt
the needie is above the needie plate.
To begin setting your machine for straight stitching,
cepress and hola reverse-stiten button in, then side
tie stich oatiern selector until it is alignec with the
blue colour Dar,
*
Neecie
Position
La
r
ab
e
Sttcn
wien
[EEE
E
e Stich Length: 1.5-4 to suit fabric
Straight stiiching can be performed with pattern group
selector set on any pattern group and stitch width
leverat i only,
Adjusting Stitch Length
The stich length cial controis the length of stiches.
Tre numbers around the edge of the cial express
stitch length in mm; the lower the number, the shorter
the stitch. Generally, shorter stitches are best for light-
weight fabric. The area from 0 to 1 is used for the
adjustment of zig-zag satin stitching (see page 40).
Setting the Dial
e Turn dial so that stich length cesired is positioned
under wy symbol.
+ To shorten stitch length, turn cial toward a lower
number.
+ To lengthen stitch length, turn dial toward a higher
number.
For reverse stitching, depress push button located in
centre of dial, hold in until reverse stitching is com-
pietec, then release push button.