Singer 1280 - Page 19

Operating Machine
Connecting Machine
Before plugging in your machine, be sure that the vot-
age
and
number
of
cycles
indicated
on
the
electrica:
namenlate A, conform to your electrical power Supply.
if
your
speed
controller
cord
has
a
motor
discon-
nect
plug,
push
plug
B
into
the
receptacie
at
the
right
end
of
machine.
Then
connect
plug
€
to
your
socket
outlet.
if
the
speed
controller
cord
is
wired
directly
to
the
motor,
simply
connect
plug
€
to
your
socket
outiel.
CAUTION:
Disconnect
the
power
line
piug
from
the
socket
outlet
when
changing
needles,
feet,
or
needle
plates
or
when
leaving
the
machine
unattended.
This
eliminates
the
possibility
of
starting
the
machine
by
accidentally
pressing
the
speed
controller.
if your machine has a sewing light switch, press or
turn switch on the machine, as required.
ff machine has a three-position switch:
a The OFF setting (switch moved to O symbol).
e
The
MIN.
setting
(switch
moved
to
|
symbol)
ai-
lows
the
maximum
control
for
special
jobs.
e The MAX. setting (switch moved to 13 symboi) al-
lows for full speed capacity of the machine.
To run the machine and control speed, press the
speed controller D with your foot. The harder you
press, the faster the machine will sew. To stop ma-
chine, remove foot from controller.
CAUTION: Because of the up and down movement
of the needle, you must work Carefully and watch the
sewing area when operating the machine.
18