Singer 1280 - Page 21

The Bobbin Thread
Winding the Bobbin
Preparation Steps
1. Raise tne presser foot and turn hand wheel toward
you until needie is in highest position.
2.” Loosen hand wheel knob A by turning it toward you
with the right hand while holding hana whee! with
the ieft hand.
3. Place thread spoo! on sped! pin with thread retain-
ing sit B io the right. (Break paper at the end of
spoo' if necessary.)
* Place spool holder C on spooi pin and press firmly
against the thread spoo!.
Winding Steps
e Snap thread into thread guide post D and open top
cover,
e Lead thread around bobbin winder tension disc E,
as Hiustrated, and through smali hole in bobbin from
inside out
e Place bobbin on spindie and move bobbin winder
F to right.
e Hold thread end and start the machine. Cut off
ihreac end after a few coils have been wound.
* Wien requires amount of thread has been wound
(winding will stop when bobbin is ful) stop machine
and cut connecting thread.
* Move bobbin winder fo the left and remove bobbin.
e Hold hand wheel and tighten hand wheel knob.