Singer 1305 - Bobbin Case Threading and Insertion; Threading the Bobbin Case; Inserting the Bobbin Case

?kr€aduiq
the
)3’obbiii
Case
Hold the
bobbin case between
the thumb and
forefinger of
your left
hand with
the
slot
in the
edge
facing up.
Hold the wound bobbin between the thumb
and
two fingers of your right
hand
with
the thread on
top leading away from you (see picture).
Insert
the bobbin into the
case, pull the
thread
into the
slot; then down under the spring, until it
(Be sure the
needle is
at its
highest point.)
Hold the bobbin cuse with
your left
hand
by the hinged-latch, with
the metal finger
of
the case
pointing
up and
in
line with
the
notch at
the top of the shuttle raceway.
Release the hinged-latch,
and
fitting
the
centre of the bobbin over the center-pin
protruding from the raceway, press
the bobbin
gently into
position, being sure
that the metal
finger
flts
into
the notch of the raceway.
The
5
or
6
inches
of
thread hanging freely
from the case will be brought
up
later through
the
ho’e in
the
centre of the meedle plate.
Close the
slide
plate.
enters the
delivery
eye.
6