Need help?Do you have a question about the Singer 20U63 and is the answer not in the manual?
General| Max Stitch Length | 5 mm |
|---|---|
| Weight | 10 kg |
| Operation | Electric |
| Stitch Type | Zigzag |
| Stitch Options | Zigzag, straight stitch, and variations |
| Type | Industrial Sewing Machine |
Protects the thread take-up mechanism.
The main cover plate on the machine's front.
Side panel of the sewing machine arm.
Top cover of the sewing machine arm.
Component of the bobbin winder mechanism.
Assembly for the thread take-up lever.
The horizontal shaft within the machine arm.
Component of the thread take-up mechanism.
Wheel for manual control, often with motor.
The main component holding the needle.
Rod that holds the presser foot.
Metal plate under the needle with feed dog cutouts.
The foot that holds fabric down.
Controls zigzag stitch pattern.
Mechanism for advancing the hook.
Holds lubricating oil for the machine.
Adjusts stitch width/bight.
Component for stitch control settings.
Mechanism for stitch width adjustment.
Gear assembly for the upright arm shaft.
Shaft that drives the hook assembly.
Bushing supporting the rotating hook drive shaft.
Retains the rotating hook shaft.
Holds the bobbin case.
Component that holds the bobbin.
Spring for the bobbin case latch.
Adjusts feed dog height or rate.
Lever to control feed direction.
Connects feed control mechanisms.
Connects feed lifting rock shaft to crank.
Shaft assembly for lifting feed dogs.
Crank assembly for the feed rock shaft.
Teeth that move fabric.
Mechanism to raise/lower the presser bar.
Assembly for thread tension control.
Nut to adjust thread tension.
Lever that lifts/lowers parts.
Special presser foot for zippers.
Hinged presser foot for various stitches.
Foot for creating hems.
Lubrication device for the machine.
Protective cover for the belt.
Upper part of the belt guard.
Helps guide fabric edge.
Protects fingers from moving parts.
To Next Page
