24
3~5
0.5~1
1
2
4
3
1
2
4
3
Prepare
Note:
foot.
2. Measure diameter and thickness of button and add 0.3
cm (1/8") for bar tacks; mark buttonhole size on fabric.
3. Place fabric under the foot, so that marking on the
buttonhole foot aligns with starting marking on fabric.
Lower the foot, so that the buttonhole center line marked
on the fabric aligns with the center of the buttonhole foot.
Density varies according to the fabric.
Always test sew a buttonhole on the fabric you are using
to sew the buttonhole.
Follow the 4-step sequence changing from one step to
another with the stitch pattern selector dial. Take care not to
sew too many stitches in steps 2 and 4. Use seam ripper and
cut buttonhole open from both ends towards the middle.
Adjust the stitch length dial between "0.5-1" to set stitch density.
1. Take off the general purpose foot and attach the buttonhole
How to sew 4-step buttonholes
To Next Page
Loading...
