Singer 5107 - Straight Stitching; Adjusting Straight Stitch Settings

threading the machine
A
3
4~~~~~~
8
•Raise the presser
toot to release tension
*Thread the needle-thread
tension 4.
Slide
discs and make
sure needle is in highest
thread over
metal plate into tension
discs,
position.
Lead
thread under needle-thread
tension and
* Place spool
pin felts from accessori
es over tension
wire by firmly pulling
thread up and
spool
pins. Then place spool
of thread on left
over to the right.
spool pin over
felt, keeping spool
thread re. Pull thread
to left behind point
5. guiding
taining slit
A on top.
thread
up toward take-up lever.
* Keep right hand
on spool of thread
to hold * Thread take-up
lever 6, as illustrated,
Then
firmly
in place while threading
machine,
pass thread back down
through point 5.
* Place thread
through thread guide
1, as * Continue
to guide thread through
points, 7
shown.
and 8, as shown.
• Sna thred int thred guie 2.*
Thread needle from front to
back and draw
* Snap thread
into thread
guide 2.
about
10cm (4
inches) of
thread through
eye
* Pass thread
through pointS3,
of needle.
14