Singer 6201; 6211 - CHANGING SNAP-ON PRESSER FEET; CHANGING SCREW-ON PRESSER FEET

CHANGING SNAP-ON PRESSER
FEET (B),(D),(J)
Your machine
comes with the General
Purpose Presser Foot
(B) already at-
tached, You
can easily change to any
one of the other presser
feet which snap onto
a
common shank by following
the directions below.
1. Raise needle to its highest
position
2 by turning hand wheel toward you.
. Raise presser foot using presser foot
lifter at back
of machine.
. Push toe of presser foot (1) up, until it
N> -,snaps off the shank (2).
. Remove foot from machine
* Place new foot
under center of
3
shank.
. Lower presser foot lifter, fitting shank
over presser foot pin (3).
.Don't
turn screw.
Instead, push
presser
foot screw (4) down,
firmly
4
CHANGING SCREW-ON PRESSER FEET (H),(G)
Some special presser feet can be purchased at your sewing center with built-in
shanks that can be replaced as follows:
. Raise needle and presser foot.
0
* Loosen
presser
foot
screw
(1)
and
2
7
remove
presser
foot
with
shank
(2),
1
guiding it toward
you and to the right.
. To
replace presser foot
with shank,
/ hook shank around the presser bar
and tighten presser toot screw with
bIB (the use of acoin,
7