Need help?Do you have a question about the Singer Brilliance 6160 and is the answer not in the manual?
General| Power supply type | Electric |
|---|---|
| Type | Automatic sewing machine |
| Display | LCD |
| Free arm | Yes |
| Control type | Buttons |
| Sewing speed | 750 |
| Stitch width | Variable |
| Product color | Blue, White |
| Buttonhole type | 1 Step |
| Number of programs | 60 |
| Number of button holes | 4 |
| Sewing machine functions | Sewing |
| Number of needle positions | 13 |
| Sewing machine accessories included | Buttonhole foot |
Instructions for removing the face cover of the sewing machine.
Steps to remove the front and rear covers of the sewing machine.
Instructions for removing screws located at the bottom of the sewing machine.
Procedure to remove the shuttle race cover and its spring plate.
Instructions for removing the thread guide pin.
Detailed steps for removing the front cover using a screwdriver.
Subsequent step to remove the rear cover of the sewing machine.
Procedure for checking the needle height against specifications.
Procedure for adjusting the needle bar to set the correct needle height.
Procedure for checking the timing between the needle and shuttle hook.
Procedure for adjusting the timing of the shuttle hook and needle.
Procedure for checking the clearance between the needle and shuttle hook.
Procedure for adjusting needle clearance by sliding the needle bar support.
Procedure for adjusting the shuttle race position using screws.
Procedure for checking the needle's evenness at left and right positions.
Procedure for adjusting needle position using a screw.
Checking and adjustment procedure for horizontal feed timing.
Procedure for checking and adjusting vertical feed timing.
Procedure for checking feed dog position relative to needle plate.
Procedure for adjusting feed dog position using a screw and shaft.
Procedure for checking the feed dog height above the needle plate.
Procedure for adjusting feed dog height using a screwdriver.
Procedure for checking and adjusting needle threader in horizontal direction.
Procedure for checking and adjusting needle threader in vertical direction.
Procedure for checking presser foot parallelism and clearance.
Procedure for adjusting presser foot height using screws.
Procedure for checking thread tension value at dial setting '5'.
Procedure for adjusting thread tension when the front cover is installed.
Procedure for adjusting thread tension after removing the front cover.
Procedure for positioning the motor origin point for zigzag stitch.
Procedure for positioning the motor origin point for stitch length control.
Identification and connections of the SW & CPU board.
Identification of the LCD Unit and its part number.
Identification of the AC Power Board and its part number.
To Next Page
