Additional Presser Feet page 2
CORDING FOOT
The Cording Foot is used for sewing piping (cording) between two layers of
fabric in one easy operation.
Machine Preparation
• Differential Feed: Set to “N”
• Needles: You may use both the right and left needle, or left only
• Upper Knife: Engaged
• Stitch Length: Set to “N”
• Foot: Attach (snap-on) Cording Foot
Sewing Instructions
• Raise the presser foot
• Set the needle(s) at the highest position
• Layer the piping between the two layers of fabric so that the piped edge lays towards the
inside of the fabric
• Line up the edge of the fabric along the upper knife
• The piping (cording) must line up with the groove in the presser foot (guide 1)
• Lower the presser foot and begin to sew
Note: Make sure the piping follows the groove of the Cording Foot as you sew.
To Next Page
Loading...
