Singer S800 - Page 66

64
0DUN
0DUTXH
0DUFD
5. Carefully mark the position of buttonhole on your garment.
6. Place the fabric under the foot. Pull out the bobbin thread
underneath the fabric to a length of about 4 inches to the
rear.
7. Align the buttonhole mark on the fabric with the mark on
the buttonhole foot, and then lower the buttonhole foot.
8. While holding the top thread, start the machine.
* Sewing will be completed automatically in the following order.
9. When sewing is finished, use a buttonhole opener/seam
ripper to open up the fabric in the center of the buttonhole.
Be careful not to cut any of the stitching.
Buttonhole foot alignment position
Position d’alignement du pied boutonnière
Posición de alineación del pie de ojaladora
Fabric marking
0DUTXHGXWLVVX
0DUFDGHPDWHULDO
Fabric marking
0DUTXHGXWLVVX
0DUFDGHPDWHULDO
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7
Note: It may be helpful to place a pin in front of the
bartack as you cut the buttonhole open, to prevent
cutting the stitches.