11
INSTALLATION
INSTALLATION OF THE WATER INLET PIPE
Fix the water inlet pipe to the tap.
Tightly screw the other end of the water inlet hose on to the water inlet valve (with rubber seal
ring inside).
Connect: Tightly screw the clamping nut (with straight connector side) on the water inlet hose
to the water tap (with thread for garden nozzle). If it is required to feed water, simply
open the water tap.
Separate: Close the water tap and tightly unscrew the clamping nut.
Note: When tightening the clamping nut, evenly apply the force and do not twist the water inlet
valve to avoid breaking of water inlet valve joint.
+
Water inlet hose
Clamping nut
Connect Separate
To Next Page
Loading...
Need help?
General
