SINJI SITH-0109 - Product Setup and Operation; Tower Heater Assembly; Initial Operation Instructions

1. ASSEMBLING THE TOWER HEATER
When installing the base, place the heater upside down on the packaging foam or other soft surface for avoid scratching.
1.1
Take the two parts of the base out of the packing box.
Align the two holes in the base and connect them.
1.2
Take the nut from the heater.
1.3
Align the bottom of the heater with the hole of the
base,and tighten the nut.
2. OPERATION INSTRUCTION
Completely uncoil the cord and plug the heater directly into a
220240 Volt grounded AC wall outlet. Be sure the plug fits tightly.
A loose fit can cause overheting and damage the plug.
The plug and cord may feel warm during normal usage.
Avoid extension cords.
Serrure
Srew head avoid hole
Center hole
Base
Fixing nut
Cable
EN
Rotation on/off
Control Switch
Air Inlet
Handle
Air Outlet
Base
MIN
MAX