3. FUNCTIONS
3.1 FUNCTION
If you turn the knob to the heater icon, the heater will work as a regular fan , without heating.
3.2 HEATING FUNCTION
If you turn the knob to the singular stripe, the heater will start producing wind with a low heat.
If you turn the knob to two stripes, the heater will start producing wind with a high heat.
3.3 OFF FUNCTION
If you turn the knob to “OFF”, the heater will turn off.
3.4 THERMOSTAT FUNCTION
You can turn the knob to from “MIN” to “MAX”. Point the knob in between these values. The tower heater will heat until
the temperature you point to has been met. When environment temperature is met of the setting point is met, the
heating element will stop working, If the environment temperature is lower than your setting point, the heating element
will continue to work until this temperature is met.
3.5 OSCILLATION FUNCTION
If you turn flick the on/off switch on the back of heater, you can turn the oscillation function on or off.
“O”= OFF
“—”=ON
4. STORAGE AND MAINTENANCE
1. Turn off the power and unplug the tower heater before cleaning it.
2. After the product is completely cooled, wipe the outer surface with a soft cloth, and use a soft brush to clean the
ventilation holes.
3. After cleaning the tower heater, wait until the product is completely dry. It can now be used again, or stored inside
of the original packaging. (Store the tower heater in a dry and ventilated place.)
Note: Do not rinse directly with water during the cleaning process to avoid damage to the product.
NLEN
To Next Page
Loading...