EasyManua.ls Logo

sinmag HS-3 - HS-3 Slicer Cleaning and Maintenance; HS-3 Slicer Cleaning Instructions; HS-3 Slicer Safety Attention

sinmag HS-3
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CLEANING AND MAINTENANCE
5
Clean and Maintenance
1. Please always keep the conveyer belt clean and use the brush and water
to clean the conveyer belt.
2. Remember to switch off the electricity after daily use. Please use the soft
cloth to clean outside part of the machine and use the brush to clean the
inside part.
3. Normally there are much cake crumb remained on the working table, do
clean it and always keep it clean.
Attention
1. Nobody will be allowed to put his fingers close to the running blades.
2. When the blades are dull, do not push the cake by hand, switch off the
power supply first and then replace them.