SINMAG SM-402 Mixer
W & P Reedy Pty Ltd 02-9533-9522
www.wpreedy.com.au
Page 6
WARNING
Danger of electric shock
Safe Operating Procedure:
1. Check that the machine is clear of all objects and that the switches are off.
The operator should never tamper with or make
repairs to this machine.
All maintenance other than approved cleaning
operations to be carried out by trained
technicians only. Contact W & P Reedy to
confirm authorised technicians.
2. Check and place the electrical cord in the appropriate power socket and ensure
that the power rating and machine detail are the same before turning the power on.
3. Push the green start button to operate the mixer.
4. Test red safety cut-out operation by pushing the mushroom
button in. ( See picture )
The mixer must stop operating immediately. If not, do not use the
machine; call supervisor and advise W & P Reedy.
5. Test the slide safety guard by sliding the guard open and then closing and
pushing the green start button again. The mixer must stop operating immediately,
when the guard is opened. If not, do not use the machine; call supervisor and advise
W & P Reedy.
6. Test the handle switch by lowering the bowl and then raising the bowl, then push
the green start button again. The mixer must stop operating immediately, when the
bowl is lowered. If not, do not use the machine; call supervisor and advise W & P
Reedy.
7. During normal operation do not place any instruments or hands inside the
mixing area or around the planetary.
8. Never by-pass micro switches and run the machine while the guards are
off.
9. Fully isolate machine from electric power source before cleaning.
To Next Page
Loading...
