What to do if SINO SN-50 Water Pump doesn't respond when pressing the power button?
If your SINO Water Pump does not respond when you press the power button, it could be due to a low battery and no AC power supply connected. Connect the AC power supply and keep charging the battery. If this does not solve the issue, the power system may have a failure, and you should send it back to the factory.
Why does the “Occlusion” alarm frequently occur in the infusion process of SINO Water Pump?
Frequent “Occlusion” alarms during the infusion process of your SINO Water Pump can occur if the infusion apparatus pipeline is tied or the roller clamp isn't open. Recheck the pipeline of the infusion apparatus. Alternatively, the pressure level might be set too low, so increase the pressure level. If the issue persists, there may be a failure in the pressure testing system.
How to fix “Drip Error" message that appears frequently when the drip sensor alarm function is enabled on SINO SN-50?
If the “Drip Error" message appears frequently when the drip sensor alarm function is enabled on your SINO Water Pump, it may be due to incorrect installation of the drip sensor. Reinstall the drip sensor correctly. It could also be that the infusion apparatus is inappropriate or not calibrated properly; select a calibrated infusion apparatus or recalibrate the infusion apparatus.
Manual stipulations and general safety overview for the infusion pump.
Technical characteristics, parameters, RS232 interface, and multi-channel injection.
Procedures for pump installation, power on/off, and system self-test.
Connecting components, selecting modes, and setting infusion parameters.
Guide to diagnose and resolve common malfunctions and error messages.
General| Model | SN-50 |
|---|---|
| Category | Water Pump |
| Power | 50W |
| Max Head | 2.5M |
| Voltage | 220-240V |
| Frequency | 50Hz |
| Cable Length | 10M |
| Type | Submersible |
| Inlet/Outlet Size | 1 inch |
To Next Page