Sinotec T1311LS - Installation and adjustment

as the default setting.
safety and for operating the machine correctly.
assemble
After you have openedthepackage,please
leanthewashingmachinegentlydownona
soft cloth (like a towel or a blanket).Installthe
bottomplatetothebottomofthemachinewith
theeightscrewsandacrossscrewdriver,then
liftthemachineupgently.Seetothefigure:
therefor you can't adjust it.
activate a single wash cycle.
Used to select the desired water level.Understandbymode,itcanbeselectedfromoneto
eight.
The water level of "standard", "intensive" and "gentle" can be adjusted. The default settings
for the water level for washing is the 5th and for rinsing it is the 6th level.(the default water
level of "standard" is a perceptive gear.)
As a default the rinsing water level will always be one level higher than for the washing level
except when the highest/lowest level is selected, then the water level for rinsing and washing
would be the same.
Thewaterlevelof "quick"can'tbeadjusted, the default setting of the 5th level applies.but
itcanbe topped-up. (Thetypeof XQB90-91Acanadjustwaterlevelwhenselect"quick"
washingprogram.)
“Air-dry" washing program isa set process of spinning that do not require the addition of water.
Its water level button is invalid.
and drain the water in the last stage as usual.
"water-keeping".
When a program is already running, the "water-keeping" button is invalid after the last drain.
Pressing the "water-keeping" button during the last drain can only activate a drained or
undrained option. Pressing the start/pause button in an attempt to suspend the drain in the
program and then pressing the "water-keeping" button will only activate an undrained option.
The "standard", "intensive", "gentle" and "quick" washing programs defaults to "wash, rinse
and spin". Before the "standard", "intensive" and "gentle" begin to wash, the system can
select the soak function. The "self-dry" washing program is fDCed on"soak-wash-rinse-spin"
and can never be adjusted. "Air-dry" washing program is a set process of spinning and do not
allow for the option to soak, wash and rinse.
Every program usually drains the water after the completion of a wash/rinse cycle. When
"water-keeping" is activated, the tub will not drain and keep the water if it has detected having
water inside. The light will start flashing followed by a buzzer sounding for 5 seconds every 5
minutes to notify the user. Press the "water-keeping" button again to deactivate (this will turn
the water-keeping light off and turn the drain light on). The program will continue to the next
cycle.
therefor the amount of times
activate a rinse and spin cycle.
Whenpressing the"wash"buttonundertheprogramalreadyset(orthestateof
suspension),thewashtimecanbeselectedrecurrentlyfromzerototwenty-five.