Sinotec T1311LS - Control Board Function Introduction; Installation of Drain Hose; Usage of the Drain Hose; Placement of Upper Water Drain Hose

Installation of drain hose
spend
Used to select programs automatically, when selecting a program in standby mode,the
program will follow the following cycle rules:
1Whenselecting the"soak"function,theprogramswillrunwithout"quick".
selecting the
When pressing the "process"button for 5 seconds, the standard light flashes and the
program enters into the testing procedures with 5th water level and full water level.
When pressing the "spin" button under the program already set, the time of spin can be
selected recurrently from zero to nine.
drainage
including
It is set at 40 minutes as the default.
Pressing "spin" button for two seconds can activate a single spin cycle.
Notice: single wash, spin and rinse are effective only under the standard, intensive and
gentle modes.
When pressing the "rinse" button under the program already set. the times of rinse can be
selected recurrently from zero to three.
Press this button to connect the power. To switch the power off, press this button again.
If you press this button and do not press any other button within 10 minutes, the machine
will automatically switch off. After the washing programs finished, the power will be
automatically switch off after the buzzer has sounded six times to notify the user.
ensure
should
be
the
To extend the hose, purchase one
separately adhering to the following:
The inner diameter of the extra hose
shall not be less than 30mm, and the
length shall not be exceed 1.5m.
ON/ OFF
“ON/OFF”