18
• push stick when cutting small workpieces (distance between saw blade and fence
<120mm) and rip-fence with small
NOTICE
When cross-cutting round timber, a template or a holding device is necessary to
secure the workpiece against twisting and the use of a suitable saw blade is
necessary.
6.3.3 Mitre cuts (cross-cuts) and wedge-cutting
When performing this operation, the following equipment shall be used for safe working:
• Mitre gauge
• the saw blade guard
• the riving knife
• the tableinsert
Cross-cuts:
Mitre cuts in the range 0-90° can be carried out by pressing the workpiece to be cut firmly
against the stop surface of the mitre gauge.
Wedge cuts:
To do this, set the rotary part mitre fence to 0° and secure it with the adjusting handle. Position
the workpiece and saw through with even pressure.
WARNING
Only remove workpieces (wedges) after the machine has come to a standstill. To do
this, switch off the machine and wait for the saw blade to come to a standstill.
6.3.4 Cutting boards
When performing this operation, the following equipment shall be used for safe working:
• The table extension
• Cross-cut-fence or rip fence with support for the workpiece
• the saw blade guard
• the riving knife
• the workpiece downholder
• the table insert
• push stick when cutting small workpieces
• (distance between saw blade and fence <120mm)
6.4 After working process
NOTICE
After the working process the machine must be turned off:
• Switch off the machine
• Disconnect the machine from the power supply.
• Retract saw blade completely.
CAUTION
Feed only with the hand on the mitre gauge (hands away from the wood).
6. OPERATING INSTRUCTIONS Cont...
To Next Page
Loading...
