SIP 01446 User Manual

44
FOR HELP OR ADVISE ON THIS PRODUCT PLEASE CALL OUR
CUSTOMER SERVICE HELP LINE : 01509 500359
Please dispose of packaging for the product in a responsible
manner. It is suitable for recycling. Help to protect the
environment, take the packaging to the local amenity tip and
place into the appropriate recycling bin.
Never dispose of electrical equipment or batteries in with
your domestic waste. If your supplier offers a disposal facil-
ity please use it or alternatively use a recognised re-cycling
agent. This will allow the recycling of raw materials and help
protect the environment.
Ref:060406
1
12” Heavy Duty
Table Saw
Please read and fully understand the instructions in this
manual before operation. Keep this manual safe for
future reference

SIP 01446 Specifications

General

Blade Diameter	210mm
Bore Diameter	30mm
Max Cutting Depth at 90°	70mm
Arbor Size	30 mm
Voltage	230V
Supply	230 V

Summary

Declaration of Conformity

Parts List (C)

General Safety Instructions

Specific Safety Instructions

Safety Devices

Technical Specifications

Parts List (B)

Parts List (A)

Specified Conditions of Use

Electrical Connection

Assembly Instructions

Fitting the Stand

Locate the 2 x side sections and the 1 x front and 1 x rear sections of the saw stand and the fixing kit.

Fitting the Feet

Locate the 4 x feet and fit them in their correct positions.

Fitting the Front Feet

Fit the 2 x front feet using M8 bolts, washers and nuts.

Fitting the Rear Feet

Fit the 2 x rear feet using M8 bolts, washers and nuts.

Fitting the Front Fence Rail

Align and attach the front fence rail to the main table and extension tables.

Fitting the Rear Fence Rail

Align and attach the rear fence rail to the main table and extension tables.

Fitting the Rip-Fence

Fit the rip fence assembly onto the scale mount and slide onto rails.

Troubleshooting

Care and Maintenance

Replacing / Tensioning the Drive Belt

Re-tension or replace the main drive belt to ensure correct tension.

Setting the Distance Between the Blade and the Riving Knife

Adjust the gap between the blade and riving knife to be between 3mm and 8mm.

Changing the Saw-Blade

Operating Instructions

Making Cuts with the Rip-Fence

General Operating Precautions

Risk of Kickback

Drawing-in/Trapping Hazard

Making Straight Cuts

Making Mitre Cuts