6
SPECIFIC SAFETY INSTRUCTIONS
1. Use only the blade flange specified for this tool.
2. Be careful not to damage the arbor, flange (especially the installing surface) or
bolt. Damage to these parts could result in blade breakage.
3. Make sure that the table base is properly secured so it will not move during op-
eration.
4. For your safety; remove the chippings and work debris etc. from the table top and
from inside the extraction port before each operation.
5. Avoid cutting nails / screws etc; Remove all obstructions from the work-piece be-
fore cutting.
6. Make sure the arbor lock is released before switching on the saw.
7. Be sure that the blade does not come into contact with the base when the blade is
in the lowest position.
8. Hold the handle firmly.
9. Do not perform any operation freehand. The work-piece must be secured firmly
against the base and guide fence with the clamp during all operations; Using your
hand may cause severe injury.
10. Keep hands out of path of saw blade, never reach around saw blade.
11. Make sure the blade is clear of the work-piece before the switch is turned on.
12. Before making the first cut using the saw, let it run for a while; Watch for vibra-
tion or wobbling that could indicate poor installation or a poorly balanced blade. Ad-
just or replace as necessary.
13. Allow the blade to run up to full speed before cutting.
14. Stop operation immediately if you notice anything abnormal.
15. Do not attempt to lock the trigger in the ON position.
16. Wait for the saw blade to stop completely and remove from mains supply before
servicing or adjusting tool.
17. Be alert at all times, especially during repetitive, monotonous operations. Don't
be lulled into a false sense of security. Blades are extremely unforgiving.
18. Use of improper accessories such as abrasive wheels may cause damage to the
saw and surrounding area as well as increasing the risk of injury.
19. Turn off the saw and wait for it to complete stop before moving work-piece or
changing settings.
20. To reduce the risk of injury, return, carriage to the full rear position after each
crosscut operation.
21. Do not modify the saw to do tasks other than those intended.
CAUTION: The warnings and cautions mentioned in this user manual
can not cover all possible conditions and situations that may occur. It
must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be applied.
39
Ref. No. Description Qty.
B-94 Elastic Lock 2
B-95 Lock Nail Bush 1
B-96 Hexagon Socket Cap Head Screw M6 X 25 1
B-97 Active Board 1
B-98 Active Board Block 1
B-99 Lock Handle 1
B-100 Handle Sleeve 1
B-101 Lock Handle Spring 1
PARTS LIST (B)
To Next Page
Loading...
Need help?
General
