40
EXPLODED DIGRAM (C)
5
GENERAL SAFETY INSTRUCTIONS….cont
NEVER LEAVE THE TOOL RUNNING / CONNECTED WHILST UNATTENDED:
Turn off the tool and disconnect it from the mains supply between jobs. Do not leave
machine until it comes to a complete stop.
DO NOT ABUSE THE MAINS LEAD: Never carry the tool by the mains lead or pull it
to remove the plug from the mains socket. Keep the mains lead away from heat, oil
and sharp edges. If the mains lead is damaged, it must be replaced by the manufac-
turer or its service agent or a similarly qualified person in order to avoid unwanted haz-
ards.
CHECK FOR DAMAGED PARTS: Before every use of the tool, a guard or other part
that is damaged should be carefully checked to determine that it will operate correctly
and perform its intended function. Check for alignment of moving parts, free running of
moving parts, breakage of parts, and any other conditions that may affect its opera-
tion. A guard or other part that is damaged should be correctly repaired or replaced by
an authorized service centre unless otherwise indicated in this instruction manual. Have
defective switches replaced by an authorized service agent. Do not use the tool if the
switch does not turn it on and off.
KEEP ALL GUARDS IN PLACE: And in full working order.
MAINTAIN TOOLS WITH CARE: Keep tools sharp and clean for the best and safest
performance. Follow instructions for lubricating and changing accessories. All extension
cables must be checked at regular intervals and replaced if damaged. Always keep the
hand grip on the tool clean, dry and free of oil and grease.
USE ONLY RECOMMENDED ACCESSORIES: Consult this user manual for recom-
mended accessories. Follow the instructions that accompany the accessories. The use
of improper accessories may cause hazards and will invalidate any warranty you may
have.
REMOVE ADJUSTING KEYS AND WRENCHES: Form a habit of checking to see
that keys and adjusting wrenches are removed from the tool before every use.
SECURE THE WORKPIECE: Use clamps or a vice to hold the work-piece . This frees
up both hands to operate the tool.
DO NOT OVERREACH: Keep proper footing and balance at all times.
USE THE RIGHT TOOL: Do not use the tool or attachment to do a job for which it
was not designed.
DO NOT FORCE THE TOOL: It will do the job better and more safely at the rate
which it was designed.
DO NOT OPERATE POWER TOOLS IN EXPLOSIVE ATMOSPHERES: Do not use
the tool in the presence of flammable liquids, gases, dust or other combustible sources.
Power tools may create sparks which can ignite the dust or fumes.
DO NOT EXPOSE THE TOOL TO RAIN OR USE IT IN WET CONDITIONS: Water
entering a power tool will greatly increase the risk of electric shock.
HAVE YOUR TOOL REPAIRED BY A QUALIFIED PERSON: The tool is in accor-
dance with the relevant safety requirements. Repairs should only be carried out by
qualified persons using original spare parts, otherwise this may result in considerable
danger to the user.
To Next Page
Loading...
Need help?
General
