SIP SPEEDO-REVCOUNTER 2.0 User Manual

Simply dene the valve as the
starting point and the terminal
point to measure the wheel
circumference with a measuring type.
Hold the button down for 3 seconds to enter the
transmission ratio settings.
Press button once to choose the setting number.
The tire circumference setting is changed from
1,000mm to 1,300mm.
Speedometer drive ratio setting (ADJ2 setting is ‘Int’)
E.g.: You want to set the transmission ratio at 0.80.
Hold the button down for 3 seconds to move to the
digit you want to set.
Press button once to choose the correct setting .
15161400
Speedometer drive - state number of teeth
Data is received through the speedo shaft. The table below shows some
original data for your reference - make sure to check components,
respective number of teeth.
1. The transmission ratio setting range:
0,50 - 1,00.
2. Setting unit: 0,01.
3. The default setting: 1,00.
The transmission ratio setting is changed from
1.00 to 0.80.
Press the button down for 3 seconds to return to
the ADJ 3 screen.
Press the button once to enter the ADJ 4 menu
(RPM pulse setting).
NOTE!
Vespa 125 GT/GTR/Super/TS/150
T4/GL/GS/Sprint/V/Super/Rally/
P150S
Vespa 125 GT/GTR/Super/TS/150
T4/GL/GS/Sprint/V/Super/Rally/
P150S
Vespa 125 GT/GTR/Super/TS/150
T4/GL/GS/Sprint/V/Super/Rally/
P150S
Vespa 50/PV/ET3/PK50/S/SS/XL
Vespa PK50-125 S/XL/2/HP/N/
PK125/ETS
Vespa P80-150X/P80-150E/
PX80 E Lusso/P200E/MY/P200E/
T5/Cosa
Vespa PX100-200E/
PX125-150 E Lusso/’98/
GRIMECA Vespa PX/PE Ø 16mm
GRIMECA Vespa PX/Lusso/T5/PK
Ø 20mm
Models
(examples)
speedo
drive
speedo
drivegear
transmission
ratio
teeth t1
teeth t2
art.no.
I = t2/t1
13
12
12
10
15
16
16
16
16
94430000
94420000
94430000
94420000
61730000
9444000
94445000
94450000
11
10
9
8
12
12
12
12
12
0,85
0,83
0,75
0,80
0,80
0,75
0,75
0,75
0,75
FUNCTION SETTING INSTRUCTIONS

SIP SPEEDO-REVCOUNTER 2.0 Specifications

General

Brand	SIP
Model	SPEEDO-REVCOUNTER 2.0
Category	Scooter
Language	English