10 11
WARNING!
- Only use the DC connector to connect with the DC cable from the charger that comes with the hoverboard.
- Do not inse any foreign objects into DC connector.
- Risk of arcing! Never bridge the DC charging with metal objects!
CHAPTER 7 THE MAINTENANCE OF THE HOVERBOARD
The hoverboard needs to be maintained. This chapter mainly describes the relevant steps and impoant operation
reminders to maintain it. Please make sure that the power and charge coil arc o before you do the following operation.
You should not operate when the batte is charging.
7.1.Cleaning
Make sure the power and the charge coil are o.
Wipe the shell of hoverboard with soft cloth.
WARNING!
Make sure that water and other liquids do not enter the internal pas of the balance scooter as this may permanently
damage the electronics/batteries of the scooter. There is a risk of personal inju.
7.2.Storage
If the storage temperature is below 0°C, please do not charge the hoverboard. You can place it in a warm environment
(5-30℃) for charging.
You can cover the hoverboard, in order to prevent dust.
Store the hoverboard indoors put it in a place with a d and suitable environment.
If used at lower or higher temperatures, there is a risk that the peormance of the batte will be reduced and a
potential risk of damage to the product and personal inju.
Store the product at temperatures between 5℃ - 30℃. (optimum storage temperature is 25℃)
-
-
-
-
-
Charge and store the product in an open, d area and away from ammable materials (i.e. materials that may burst
into ames).
Do not store the product in sunlight or near open re.
If the product is left with other persons for example during a holiday period, it should be paially charged (20-50%
charged). Not fully charged.
When shipped from the facto, the product has often been paially charged. Keep the product in a paially charged
state, until it is going to be used.
The hoverboard must cool down for at least 1 hour before being packed.
Must not be left inside a warm car sitting in the sun.
-
-
-
-
-
-
WARNING!
To protect user safety, users are forbidden to open the hoverboard, or you give up your warranty rights.
WARMING
Please read the manual completely and instructions below before using the product
Using another charger may damage the product or create other potential risks.
Never charge the product without supeision.
The charging period of the product should not exceed three hours. Stop charging after three hours.
The product should only be charged in temperatures 0℃ and 45℃,
If charging at lower or higher temperatures, there is a risk that the peormance of the batte will be reduced and a
potential risk of damage to the product and personal inju.
The product should only be used in temperatures between -10℃ and +45℃.
If used at lower or higher temperatures, there is a risk that the peormance of the batte will be reduced and a
potential risk of damage to the product and personal inju.
Store the product at temperatures between 0℃ and 35℃. (optimum storage temperature is 25℃)
Charge and store the product in an open, d area and away from ammable materials (i.e. materials that may burst
into ames).
Do not charge in sunlight or near open re.
Do not charge the product immediately after use. Let the product cool down for one hour before charging,
-
-
-
-
-
-
-
-
-
-
-
To Next Page
Loading...