Need help?Do you have a question about the Sita UV 80/3 RACK LCD-LCD PLUS and is the answer not in the manual?
Electrical connections must follow EN 60204-1 rules and low tension instruments must be grounded.
UV light can cause burns to skin/eyes; ensure lamp is housed and cover is inserted before connecting to power.
Mercury lamps and electrical panels are special waste and must be disposed of at specialized centers.
Verifying water connections, checking for leaks, and confirming control panel LEDs signal correct operation.
Procedures for routine checks, including quarterly inspection of quartz sleeves for maximum disinfection.
Work by trained personnel, recommended service intervals for UV lamps, quartz sleeves, and O-rings.
Diagram illustrating the recommended installation layout for the UV disinfection system.
Step-by-step guide for disassembling and reassembling the UV chamber components correctly.
Technical illustration detailing the components and layout of the UV-C chamber for model UV 80/3.
Technical illustration detailing the components and layout of the UV-C chamber for models UV 80/4 & 80/5.
Explains the electrical panel layout and component functions for RACK LCD and RACK LCD PLUS models.
Detailed diagram and explanation of the electrical board for the RACK LCD models.
Describes display sequences, status indicators, and troubleshooting for the RACK LCD model.
Details display sequences, alarms, and troubleshooting for the RACK LCD Plus model.
General| Model | UV 80/3 RACK LCD-LCD PLUS |
|---|---|
| Category | Laboratory Equipment |
| UV Lamp Power | 80 W |
| Number of Lamps | 3 |
| Mounting | Rack |
| UV Wavelength | 254 nm |
| Power Consumption | 240 W |
| Voltage | 230 V |
| Frequency | 50/60 Hz |
| Control | LCD |
| UV Lamp Type | Low pressure mercury lamp |
| Application | UV disinfection |
To Next Page
