Filter client PC by MAC Check “Enable MAC Filtering” to enable MAC Filtering.
Add PC Fill in “Client PC MAC Address” and “Comment” of the PC that is allowed
to access the Internet, and then click “Add”. If you find any typo before adding it
and want to retype again, just click "Reset" and the fields will be cleared.
Remove PC If you want to remove some PC from the "MAC Filtering Table",
select the PC you want to remove in the table and then click "Delete Selected". If
you want to remove all PCs from the table, just click the "Delete All" button. If
you want to clear the selection and re-select again, just click “Reset”.
Click <Apply> at the bottom of the screen to save the above configuration.
To Next Page
Loading...
