Sixpack Millenium - Mounting the Sixpack Direct Mount Stem; Attach Stem to Fork Crown; Position Handlebar on Stem; Align and Tighten Handlebar Clamps

Mounting the stem
3
4
8 Nm
6 Nm
No Gap
Gap
A
A
B
B
A
B
9 Nm
C
C
C
A
A
B
B
1
2
3
4
There must be no gap between the clamp and the stem.
3
Turn the rear screws of the handlebar clamp (A) in, align the
handlebar according to your needs and tighten the screws with a
torque of max 9 Nm.
Screw in the front screws (B) and tighten them to 6 Nm. It is
possible that the handlebar manufacturer species a lower torque.
8 9
2
Clean and degrease the clamping surface of the handlebar and stem.
1
Disassemble the handlebar clamps and attach the stem to the
fork crown. Screw in the two rear screws (C) and tighten them to a
maximum torque of 9 Nm.
Put the handlebar on the stem and thread the handlebar clamps
from the outside to the inside of the handlebar.