WATCH ASSEMBLY VIDEOS ON OUR YOUTUBE CHANNEL, HTTPS://SIXTHREEZERO.COM/PAGES/ASSEMBLY
Line up the stem, frame, and front wheel, then tighten.
the handlebar stem bolt.
Loosen handlebar adjustment bolt using the 6mm Allen
key. Change the angle of the handlebars to your liking.
05
The front reflector will be installed into the hole at the
top of the fork and below the head tube. Tighten with
the Phillips head screw driver and 10mm wrench.
06
Order from front to back:
LONG BOLT, WASHER, FORK, WASHER, NUT.
NOTE
ADJUST BOLT
6MM
ALLEN KEY
PHILLIPS
SCREWDRIVER
TIGHTEN
BOLT
FRONT
REFLECTOR
To Next Page
Loading...
