10
English
Installing the Electrical Connections
The electrical cable is provided separately from the control
cable. Before installation begins, connect the four leads (which
include the 3A fuses) using a red or blue crimp sleeve as
appropriate.
Warning!
Please note sharp edges or moving parts which may
damage the wires.
The value for the fuses provided with the kits must
not be changed.
The kit is appropriate only for a 12V/24V vehicle.
In case of converting any other kit model into this kit,
please change the power cable.
The electrical cables should be directed as follows:
So as not to disturb the driver or passengers.
So as not to pass near the car’s sharp or moving parts.
Note!
The external voltage connection is located under the
dash board or close to the fuse box (depending on
the car model).
In new vehicles a cellular Device connection can be
found near the fuse box. See the car’s user’s manual
under Info.
Only use the kit’s original fuses (3A).
To Next Page
Loading...