Need help?Do you have a question about the Skanti MF DSC and is the answer not in the manual?
Steps to initiate a distress call sequence until release is displayed.
Details the operation of the DISTRESS button, ON/OFF, Volume, and Tuning controls.
How to set the output power to HIGH, MED, or LOW.
Details switching to and navigating within the distress frequency display.
Describes how to activate, use, and understand the two-tone alarm signal.
Provides step-by-step instructions for initiating a manual voice call.
Procedures for receiving, viewing, and responding to individual DSC calls.
Steps for selecting a reply option and transmitting the response.
Steps upon receiving a distress call, including viewing and acknowledging.
Procedures for sending distress acknowledgements or relays.
Steps to select a SHIP call and enter the target ship's MMSI.
Choosing the DSC frequency and transmitting the call to a ship.
Steps to select a SHORE call and enter the target station's MMSI.
Choosing the DSC frequency and transmitting the call to a shore station.
Introduction to the terminal, its purpose, and supported ARQ/FEC protocols.
Covers pre-transmission checks, initiating calls, and message sending.
Step-by-step guide for performing a broadcast FEC transmission.
Detailed steps for initiating and conducting an ARQ call to a coast station.
Steps to initiate a distress call sequence until release is displayed.
Details the operation of the DISTRESS button, ON/OFF, Volume, and Tuning controls.
How to set the output power to HIGH, MED, or LOW.
Details switching to and navigating within the distress frequency display.
Describes how to activate, use, and understand the two-tone alarm signal.
Provides step-by-step instructions for initiating a manual voice call.
Procedures for receiving, viewing, and responding to individual DSC calls.
Steps for selecting a reply option and transmitting the response.
Steps upon receiving a distress call, including viewing and acknowledging.
Procedures for sending distress acknowledgements or relays.
Steps to select a SHIP call and enter the target ship's MMSI.
Choosing the DSC frequency and transmitting the call to a ship.
Steps to select a SHORE call and enter the target station's MMSI.
Choosing the DSC frequency and transmitting the call to a shore station.
Introduction to the terminal, its purpose, and supported ARQ/FEC protocols.
Covers pre-transmission checks, initiating calls, and message sending.
Step-by-step guide for performing a broadcast FEC transmission.
Detailed steps for initiating and conducting an ARQ call to a coast station.
To Next Page
General