SKC TOUCH - User Manual

Pocket Pump TOUCH
Installation/Operation Caution Guide
The SKC Pocket Pump TOUCH (Model 220-1000TC) Intrinsically Safe/Sécurité
Intrinsèque personal air sample pump was evaluated in accordance with the
following standards:
• UL 913 STANDARD FOR INTRINSICALLY SAFE APPARATUS AND
ASSOCIATED APPARATUS FOR USE IN CLASS I, II, III, DIVISION 1,
HAZARDOUS (CLASSIFIED) LOCATIONS - Edition 8 (2015)
• CSA C22.2 NO. 157-92 INTRINSICALLY SAFE AND NON-INCENDIVE
EQUIPMENT FOR USE IN HAZARDOUS LOCATIONS - Edition 3 (2003)
• CENELEC EN 60079-0 EXPLOSIVE ATMOSPHERES - PART 0: EQUIPMENT
- GENERAL REQUIREMENTS - Edition 7 (2018)
• CENELEC EN 60079-11 EXPLOSIVE ATMOSPHERES - PART 11:
EQUIPMENT PROTECTION BY INTRINSIC SAFETY “I” - Edition N/A (2012)
• IEC 60079-0 EXPLOSIVE ATMOSPHERES - PART 0: EQUIPMENT GENERAL
REQUIREMENTS - Edition 7 (2017)
• IEC 60079-11 EXPLOSIVE ATMOSPHERES – PART 11: EQUIPMENT
PROTECTION BY INTRINSIC SAFETY “I” - Edition 6 (2014)
MARKINGS*
* UKCA mark and UL22UKEX2584 added based on previously issued ATEX/IECEx
certificates
220-1000TC PocketPump, SKC Inc. SN YY9999
Class I, Groups A, B, C, D; Class II, Groups E, F, G; Class III, T4;
Class I, Zone 0, Group IIC T4; Exia -20
o
C ≤ T
a
≤ 45
o
C
II 1G Exia IIC T4 Ga
IECEx UL 16.0113, DEMKO 16ATEX 1600, UL22UKEX2584
0539 0843

Summary

Safety Warnings and Advisories

Component Substitution Warning

Substitution of components may compromise intrinsic safety.

Hazardous Atmosphere Charging Warning

Charge/replace batteries only in non-hazardous areas to prevent ignition.

Approved Charger Usage

Only use SKC charger Cat. No. 220-300 for operation.

Maximum Charge Voltage

Maximum charge input voltage must not exceed 5.5V DC.

Operational Cautions

Battery Fire and Explosion Risk

Battery may risk fire/explosion if heated or incinerated; use only SKC P76303.

Battery Pack Replacement Procedure

SKC TOUCH Specifications

General

Brand	SKC
Model	TOUCH
Category	Water Pump
Language	English