SKF TMEA 2 User Manual

Instructions Instructions
for for
useuse
Mode d’emploiMode d’emploi
BedienungsanleitungBedienungsanleitung
Instrucciones de usoInstrucciones de uso
Manuale d’instruzioniManuale d’instruzioni
BruksanvisningBruksanvisning
GebruiksaanwijzingGebruiksaanwijzing
Instrucções de utilizaçãoInstrucções de utilização
BrugervejledningBrugervejledning
KäyttöohjeKäyttöohje
!"#$%&'!"#$%&'
()*+#'()*+#'
SKF TMEA 2SKF TMEA 2

SKF TMEA 2 Specifications

General

Brand	SKF
Model	TMEA 2
Category	Test Equipment
Language	English

Summary

EU-DECLARATION OF CONFORMITY

EMC and Laser Classification

Details on the design and manufacturing compliance with EMC directives and laser safety standards.

SAFETY RECOMMENDATIONS

General Safety Precautions

Essential safety guidelines for operating the SKF TMEA 2, including handling and environmental considerations.

INTRODUCTION

Principle of Operation

Explains how the TMEA 2 system uses lasers and detectors to measure shaft misalignment.

Machine Configuration and Measuring Positions

Defines stationary/movable machines and uses clock analogy for measuring unit positions.

SHAFT ALIGNMENT TOOL

Tool Components Overview

Lists the various components included in the SKF TMEA 2 shaft alignment tool kit.

Technical Data

Comprehensive specifications for measuring units, display unit, shims, and the complete system.

INSTRUCTIONS FOR USE

Measurement Unit Settings

Guidance on selecting measurement units (metric/imperial) and checking machine feet.

Attaching and Connecting Units

Steps for attaching measuring units to shafts and connecting them to the display unit.

System Setup and Dimensions

Instructions for switching on the system and inputting machine dimensions (A, B, C).

Laser Aiming and Rough Alignment

Procedure for aiming laser lines and performing rough alignment if horizontal alignment is poor.

Measuring Sequence Execution

Detailed steps for executing the measurement cycle, including 9 and 3 o'clock positions.

Interpreting Alignment Results

Explains how to read the displayed misalignment values for vertical and horizontal alignment.

Vertical Alignment Adjustment

How to adjust the machine's vertical position using shims based on displayed values.

Horizontal Alignment Adjustment

How to adjust the machine's horizontal position based on displayed sideways values.

Alignment Verification

Procedure to re-run measurements to confirm the accuracy of the completed alignment.

Soft Foot Correction Procedure

Step-by-step guide to identify and correct soft foot conditions for reliable alignment.

ALIGNMENT REPORT

Report Data Fields

Details the specific data points captured in the SKF TMEA 2 alignment report.

ADVANCED USE

Limited Rotation Alignment

Techniques for performing alignment in applications with restricted space for unit rotation.

Troubleshooting Common Issues

Solutions for problems such as system startup failures, lack of laser lines, or no measurement values.

MAINTENANCE

Care and Cleanliness

Guidelines for handling the equipment carefully and maintaining cleanliness of optical parts.

Battery Replacement and Unit Care

Information on display unit batteries, and the need to replace measuring units in pairs.