Section 05 ELECTRICAL
Sub-Section 05 (TESTING PROCEDURE)
05-05-1
TESTING PROCEDURE 0
GENERAL
The following chart gives the engine types with
their implemented system.
CDI System Identification
Nippondenso
1. Ignition module is connected to the ignition
generator coil via a 3-wire connector
(BLACK/RED, WHITE and RED wires).
599, 699 and 809 Engines
Ignition module stamped P/N: 070000-2341
Ignition coil stamped P/N: 129700-2990 or
129700-2991
Flywheel stamped P/N: 032000-7902
➀
NIPPONDENSO CDI TRIGGER COIL WITH 3 H.T. COILS
1. Separate high tension coils mounted on carburetor flanges
2. Three-wire connector (BLACK/RED, WHITE and RED)
Ignition System Testing Sequence
When dealing with ignition problems, the follow-
ing items should be verified in this order.
Nippondenso
1. Spark occurrence/spark plug condition.
2. Electrical connections.
3. Engine stop/tether cord switches.
4. Ignition coil output.
5. Ignition module output.
6. Magneto output (ignition generator coil).
The first 2 items can be checked with known au-
tomotive equipment and other items as follows.
ENGINE
TYPE
IGNITION
SYSTEM
CHARGING
SYSTEM
OUTPUT
599, 699 and
809
➀
NIPPONDENSO
(CDI)
TRIGGER COIL
220
-
CAUTION
Whenever replacing a component in ignition
system, check ignition timing.
1
A06E0ZA
2
To Next Page