skike v07 Plus
6 2014
E.2 Directional stability - straight - and track
tuning
Basic setting: : buckle up skikes and open all 4 quick release on a
smooth, flat surface, 1-2 meter roll and then close in the loaded condition
all 4 quick release again.
Fine adjustment: If the directional stability is still unsatisfactorily while
skiking you can perform the fine tuning by loosening a quick release and
press the front wheel to the straight-line stability.
Please note that during the roll-tests the skike must be kept completely
straight (horizontal). Even slight inclinations influence the direction. This
setting method can only lead to the desired success by proper
performance!
E.3 Changing bearings
E.3.1 Dismantling:
Push pin (app. 4-5mm diameter) to the oposite bearing
●
Press bearing out of the rim by giving a slight beat , the spacer sleeve
●
falls out of it.
Press the second bearing on the opposite side out.
●
E.3.2 Assembly:
Insert bearing on a firm surface.
●
Press rim on the bearing.
●
Provide the second bearing with spacer sleeve to slip pad
●
Turn rim and press from the other side of the bearing.
●
Repeat on both sides until both bearings are fully seated in the rim.
●
To Next Page
Loading...