16.
Sanding curved edges
(Fig. 19 & 20)
1. Always sand inside curves on idler drum as shown
in figure 19.
Never attempt to sand the ends of a
workpiece on the idler drum.
Applying the end of the workpiece to the idler drum
could cause the work piece to fly up and result in an
injury.
2. Always sand outside curves on the left hand side of
the sanding disc, as shown in figure 20.
Applying the workpiece to the right
side of the disc could cause
workpiece to fly up (kickback) and result in injury.
Sanding small end surfaces
on the sanding disc (Fig. 21)
1. Use of the mitre gauge is recommended for this
operation.
2. Rest the workpiece against the edge of the mitre
gauge.
3. Always move the work across the left hand side of
the sanding disc.
4. The table may be tilted for bevelled work.
Operation
FIG. 19
FIG. 20
FIG. 21
W
ARNING
!
WARNING
!
SM 2610957110 05-08 6/5/08 7:36 AM Page 16
To Next Page
Loading...
