Skil 6239 - User Manual

Questions and Answers

M
Marilyn MartinezJul 29, 2025
What to do if my Skil 6239 Drill won't start?
- M
  murphylisaJul 29, 2025
  If your Skil Drill won't start, consider the following possibilities: * Ensure the power cord is properly plugged into a power source. * Check the power source fuse or circuit breaker; replace the fuse or reset the breaker if necessary. If the issue persists, discontinue use and seek service from an authorized Skil service center. * Inspect the power cord for any damage. If damage is found, have it replaced by an authorized Skil service center. * The switch might be burned out, in that case have it replaced by an authorized Skil service center.
N
Nancy NixonAug 6, 2025
Why does my Skil 6239 Drill not come up to speed?
- M
  Matthew FletcherAug 6, 2025
  If your Skil Drill isn't reaching full speed, here's what to check: * If you're using an extension cord, it might be insufficient or too long. Try replacing it with an adequate extension cord. * If your drill has variable speed settings, make sure it's set to the maximum RPM. * Low house voltage can also be a factor. Contact your electric company to check your voltage.
T
tammycisnerosAug 13, 2025
What to do if Skil 6239 Drill accessory binds, stalls motor, or kicks back when drilling?
- A
  Anthony FaulknerAug 13, 2025
  If the accessory binds, stalls the motor, or kicks back when drilling with your Skil Drill, consider these potential causes: * The accessory may be damaged. Discard it and replace it with a new one. * The accessory might not be rated for the drill speed. Use a properly rated accessory, as indicated by the accessory manufacturer. * The drill may be in the wrong operating mode. Set the drill to the appropriate operating mode.
T
Tammy DavisAug 21, 2025
How to fix excessive vibration in Skil 6239 Drill?
- K
  Kerri ClarkeAug 21, 2025
  Excessive vibration in your Skil Drill can stem from a couple of issues: * The accessory you're using might be bent or damaged. Replace it with a new one. * The accessory might not be securely fastened in the chuck. Refer to the 'Insert Bit' section of the manual for instructions.