14
OPERATING INSTRUCTIONS
WARNING
To reduce the risk of fire, personal injury, and product damage due to
a short circuit, never immerse your tool, battery pack, or charger in
fluid or allow a fluid to flow inside them.
Corrosive or conductive uids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing products, etc. can cause a short
circuit.
WARNING
Do not use any attachments or accessories not recommended by the
manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
WARNING
Do not attempt to modify this tool or the battery pack or create
accessories not recommended for use with this tool.
Any such
alteration or modication is misuse and could result in a hazardous condition leading to
possibly serious injury.
WARNING
To prevent accidental starting that could cause serious personal
injury, always remove the battery pack from the tool when assembling
parts, making adjustments, cleaning, or when not in use.
WARNING
Do not allow familiarity with this product to make you careless.
Remember that a careless fraction of a second is sufcient to inict serious
injury.
WARNING
Always wear eye protection with side shields marked to comply with
ANSI Z87.1, along with hearing protection. Failure to do so could
result in objects being thrown into your eyes and other possibly serious injuries.
Application
This pole saw is intended to be used for limbing and pruning of trees.
Filling Oil Tank with Bar and
Chain Lubricant
WARNING
To prevent accidental
starting that could cause
serious personal injury, always remove the
battery pack from the tool before lling the
tank with oil.
WARNING
Do not smoke or bring
any re or ame near the
oil or the pole saw. Oil may spill and cause a
re.
NOTICE:
The pole saw is not lled with oil at
the time of purchase. It is essential to ll the
tank with oil before use. Operating the pole
saw without chain oil or when the oil level is
below the minimum mark will result in damage to the pole saw. Chain life and cutting capacity
depend on optimum lubrication. The chain is automatically lubricated with chain oil during
operation.
1. Remove the battery pack from the pole saw.
2. Clean the oil-tank cap and the area around it to ensure that no dirt falls into the oil tank.
3. Position the pole saw on its side on a rm, at surface, so that the tank cap is facing
upwards. Twist the oil-tank cap counterclockwise to remove it (Fig. 5).
Fig. 5
Oil-Tank Cap
Oil-inspection
Window
To Next Page
Loading...
General