EasyManuals Logo

Skil PS4561C-00 User Manual

Skil PS4561C-00
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
MAINTENANCE
WARNING
To avoid serious personal injury, remove the battery pack from the
pole saw before inspecting, cleaning, or performing maintenance. A
battery-operated tool with the battery pack inserted is always on and can start accidently.
WARNING
When servicing, use only identical replacement parts. Use of any
other parts could create a hazard or cause product damage.
Periodically inspect the entire product for damaged, missing, or loose parts such as screws,
nuts, bolts, caps, etc. Tighten securely all fasteners and caps and do not operate this product
until all missing or damaged parts are replaced. Please contact customer service or an
authorized service center for assistance.
WARNING
Always wear safety goggles or safety glasses with side shields
during power tool operation or when blowing dust. If the operation is
dusty, also wear a dust mask.
WARNING
When cleaning the pole saw, DO NOT immerse in water or other
liquids.
WARNING
Do not at any time let brake uids, gasoline, petroleum-based
products, penetrating oils, etc., come in contact with plastic parts.
Chemicals can damage, weaken, or destroy plastic, which may result in serious personal
injury.
Cleaning
After each use, clean debris from the chain and guide bar with a soft brush. Wipe the pole saw
surface with a clean cloth moistened with a mild soap solution.
Remove the side cover, and then use a soft brush to remove debris from the guide bar, saw
chain, sprocket and side cover.
Always clean out wood chips, saw dust, and dirt from the guide bar groove when replacing the
saw chain.
Replacing the Bar and Chain
WARNING
Before performing any maintenance, make sure that the battery pack
is removed. Failure to heed this warning could result in serious personal
injury.
WARNING
Always wear gloves when handling the bar and chain. These
components are sharp and may contain burrs.
WARNING
Never touch or adjust the chain while the motor is running. The saw
chain is very sharp.
NOTICE: When replacing the guide bar and chain, always use the specied bar and chain
combination listed in the section: “Recommended Bar and Chain for this Pole Saw”.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Skil PS4561C-00 and is the answer not in the manual?

Skil PS4561C-00 Specifications

General IconGeneral
BrandSkil
ModelPS4561C-00
CategoryPole Saw
LanguageEnglish