EasyManua.ls Logo

Skoda 2014 Rapid - Cruise Control System; Fig. 96

Skoda 2014 Rapid
189 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Function
Fig. 96
Range of sensors
Read and observe and on page 103 first.
Approximate range of sensors
Area » Fig. 96 Distance behind the vehicle (in cm)
A
160
B
60
Acoustic signals and display
The interval between the acoustic signals becomes shorter as the clearance is
reduced. A continuous tone sounds from a distance of approx. 30 cm - danger
area. From this moment on do not continue reversing!
Description of the indications in the radio or navigation system display, » the
radio instruction manual, navigation system user guide.
Activation/deactivation
Read and observe
and on page 103 first.
The system is activated automatically by engaging the reverse gear. This is
confirmed by a brief audible signal.
The system is deactivated by disengaging reverse gear.
Displaying an error
If a warning signal sounds for about 3 seconds after activating the system and
there is no obstacle close to your car, this indicates a system fault. Seek help
from a specialist garage.
Note
For vehicles with a factory-fitted towing device, the system cannot be activa-
ted when towing a trailer.
Cruise Control System
Introduction
This chapter contains information on the following subjects:
Functioning
104
Operating Description 105
The Cruise Control System (CCS) maintains a set speed without you having to
actuate the accelerator pedal.
The state where the GRA maintains the speed is referred to hereinafter as the
control.
WARNING
The GRA only serves to support and does not relieve the driver of the re-
sponsibility for the vehicle operation.
Always adjust the speed and driving style to the current visibility, weath-
er, road and traffic conditions.
Functioning
Read and observe on page 104 first.
Basic requirements for start of control
The GRA is activated.
On vehicles with a manual transmission, the second gear or higher must
be engaged.
On vehicles with an automatic transmission, the selector lever must be in
the D, S position or in the Tiptronic position.
The current speed must be higher than 20 km/hr.
This is only possible within the range which is permitted by the power output
and braking power of the engine.
104
Driving

Table of Contents

Related product manuals